Batteries usually come with a partial charge.  Whatever battery you have, we suggest, you fully charge the battery before the first use.  If you think your battery is not charging fully or properly fully discharge the battery and then fully charge.



Gerbing 2.6Ah Battery


Spare and replacement batteries can be ordered here.


This is the most popular battery from Gerbing and powers most of the gloves, vests, jackets and socks.


  • To charge


Plug the charger into the wall. The led light/ lights should light up green.  When the battery is connected to the charger the light changes to red.  When fully charged the light will go green or flicker between red and green.  


Please note: Some generations of batteries and chargers are not compatible and will not indicate if the battery is fully charged/ charging.  If the lights on the charger do not change this does not mean the battery is not charging. If this is the case then please allow 4 hours for full charge.  The lights on the battery do not turn on during charging.


  • To use


Plug battery into the heated clothing.  Hold down button on battery for at least 3 seconds to turn battery on. Once on you can then hold down the battery to cycle through the different heat settings and turn it off.


The battery will not turn on unless plugged into the garment.  You can, however, find out how much power is left in the battery by holding down then button when not plugged into a garment.


Number of Lights Power Level Approx Heating Time (Full Battery)
4 100% 2 Hours
3 75% 3 Hours
2 50% 5 Hours 
1 25% 8 Hours




Gerbing Extended Life Battery with Remote

Spare and replacement batteries can be ordered here.


Works with vests, jackets, hunting blind pad etc.  This item is not compatible with gloves.


  • To charge


Plug the charger into the wall. The led light should light up green.  When the battery is connected to the charger the light changes to red.  As the battery charges the numbers on the battery display will increase. When fully charged the light will go green or flicker between red and green.  


Please note: Some generations of batteries and chargers are not compatible and will not indicate if the battery is fully charged/ charging.  If the lights on the charger do not change this does not mean the battery is not charging. If this is the case then please allow 4 hours for full charge.


  • To use


Plug battery into the heated clothing.  Hold down the power on button/ set up on battery for at least 2 seconds to turn battery on. Once on you can then press the set up and set down buttons to cycle through the 3 heating options.  Hold down the set down/ power off button to turn the battery off.


The battery will not turn on unless plugged into the garment.  You can, however, find out how much power is left in the battery by holding down either button.  The battery level goes from 1-9.


Power Level

Approx Heating Time (Full Battery)

99% 3.5 Hours
66% 7 Hours
33% 10.5 Hours

  • How to program a new remote with battery

When battery is not connected (to load or charger), Push ON and OFF button on battery at the same time, the battery LED shall read A in flashing (means "address" searching),

Then push the OFF button on remote, the flashing A in LED display shall be OFF.

To test with the battery and remote are matched push remote button OFF within 60seconds after match procedure, the LED in battery should read "F" (means "find or found") or try the battery on load and use remote to control battery.



Gerbing Next Gen and Glove Liner Battery



Spare and replacement batteries can be ordered here.


These batteries are used in the Gerbing Next Gen and Glove Liner only.

  • To charge

 

Plug the charger into the wall. The led lights should light up green.  When the battery is connected to the charger the light changes to red.  When fully charged the light will go green or flicker between red and green.


Please note: Some generations of batteries and chargers are not compatible and will not indicate if the battery is fully charged/ charging.  If the lights on the charger do not change this does not mean the battery is not charging. If this is the case then please allow 4 hours for full charge.



  • To use

 

Plug battery into the heated clothing.  Hold down the Gerbing button until it lights up.  You can the cycle through the different heat settings.  Hold down button to turn off.


Light Color Power Level Approx Heating Time (Full Battery)
Red 99% 2 Hours
Amber 66% 4 Hours
Green 33% 6 Hours