Insoles
Plug the micro USB cable into the port on the back of each insole.
Charge until the LED light on the back of the insoles turns green.
Press the power button for 3 seconds on the back of the insoles, or press the button for three seconds on the remote to turn on.
Press the power button again to change the heat level (Red = High, Blue = Medium, Green = Low) or press the appropriate button on the remote.
Press the power button for three seconds on the back of the insole to turn off, or press the power button to turn off the heat.
To pair the remote to the insoles:
Press and hold the power button on the back of the insole until the LED light starts flashing. Keep this held down.
While holding down the power button, press the “I” button on the remote to sync the remote to the insole. The flashing red light on the insole will turn to green to indicate that the remote is now paired.
Repeat steps 1 & 2 for the second insole.
3.7V Products
Charge batteries fully.
Connect the battery to the power cord on each sock.
Press the hold the red power button approx. 2 seconds until the LED light turns on.
Press the power button to change the heat levels (Red = High, Orange = Medium, Green = Low).
Press the power button again to turn off.
5V Products
Charge power bank fully. This can take anywhere from 3.5 hours to 8 hours, depending on the mAh of the battery.
Plug power bank into the item. The number of LED lights lit up on the battery indicate battery life length.
Press and hold the button on the item until the button glows red.
Press the button again to select different heat levels (Red = High, White = Medium, Blue = Low).
Press and hold the button until the button light turns off to turn off the battery.
7V Products
Fully charge the battery.
Plug the battery into the item.
Press and hold the button on the item until the button glows red.
Press the button again to select different heat levels (Red = High, White = Medium, Blue = Low).
Press and hold the button until the button light turns off to turn off the battery.